Concrete and Formwork Safety Quiz: Pouring, Striking, and Collapse Prevention
25 questions
About 13 min
Updated
0 of 25 answered
Score 0
Question 1 of 25
What must formwork safely resist?
Question 2 of 25
What documents should be available at the jobsite under OSHA 1926.703?
Question 3 of 25
What should happen to damaged shoring that cannot provide required strength?
Question 4 of 25
When does OSHA require inspection of erected shoring around a pour?
Question 5 of 25
What should support sills provide?
Question 6 of 25
Why check shore heads and base plates for firm contact?
Question 7 of 25
Can eccentric loading on a shore head be assumed acceptable?
Question 8 of 25
Why is formwork bracing important?
Question 9 of 25
What should happen before changing a tie or prop arrangement?
Question 10 of 25
Why control the pour sequence and rate?
Question 11 of 25
What if concrete starts collecting in an unplanned concentrated area?
Question 12 of 25
What should unusual movement or distress during a pour trigger?
Question 13 of 25
May single-post shores be adjusted to raise formwork after concrete placement under OSHA?
Question 14 of 25
What is reshoring intended to do?
Question 15 of 25
What establishes when forms and shores may be removed under OSHA?
Question 16 of 25
Does hard-looking concrete prove adequate structural strength?
Question 17 of 25
When may reshoring be removed?
Question 18 of 25
What should the stripping method control?
Question 19 of 25
May workers stand below an elevated concrete bucket?
Question 20 of 25
What protects against accidental concrete-bucket discharge?
Question 21 of 25
How should pressurised concrete-pump lines be managed?
Question 22 of 25
Before maintenance where unexpected operation could injure someone, what is required?
Question 23 of 25
Why avoid skin contact with wet concrete?
Question 24 of 25
Concrete gets inside a worker's boot. What should happen?
Question 25 of 25
Does passing this quiz qualify someone to design or authorise striking?
About This Quiz
Test the choices that prevent collapse and exposure during concrete placement and formwork operations. These 25 original questions cover design loads, shoring inspections, pour monitoring, removal evidence, reshoring, equipment hazards and wet cement contact.
Scope and independent practice
Independent knowledge practice, not formwork design approval, a striking permit or practical qualification. Regulatory questions use US federal OSHA concrete construction requirements, particularly 29 CFR 1926.703. HSE cement guidance supports general skin-exposure prevention; local legal requirements differ. Project-specific engineering decisions and current product instructions govern the actual work.
How to use this quiz
Choose one best answer and review its explanation. The practice pass mark is 70%, answers are shuffled and retakes are allowed. There is no universal safe stripping age: the required strength and load evidence must be established. A quiz cannot certify a formwork system or authorise changes to supports.
Primary safety guidance
Reviewed on 16 November 2026. Check current local requirements and procedures before applying the learning.
Test sling inspection knowledge with 25 questions on wire rope, chain and webbing damage, markings and safe use. Includes correct answers and explanations.
Practise lift planning with 25 questions on load weight, crane radius, charts, ground support and communication. Includes answers and useful explanations.
Test construction traffic safety with 25 questions on pedestrian routes, reversing, deliveries and site controls. Includes correct answers and explanations.