Telehandler Safety Quiz: Attachments, Stability, and Load Charts
25 questions
About 13 min
Updated
0 of 25 answered
Score 0
Question 1 of 25
What should determine the telehandler selected for a task?
Question 2 of 25
Which chart is needed when changing a telehandler attachment?
Question 3 of 25
A bucket fits the coupler but its approval for this machine is unknown. What should happen?
Question 4 of 25
What must be confirmed after fitting an attachment?
Question 5 of 25
Why can moving a load farther forward reduce allowable lifting capacity?
Question 6 of 25
A long load has a different load centre from the chart's stated conditions. What is required?
Question 7 of 25
The load will be placed at greater reach than the pickup point. Which stages need checking?
Question 8 of 25
What should be done if the applicable load chart cannot be read?
Question 9 of 25
Does a load-moment warning device replace the need to follow the load chart?
Question 10 of 25
What ground is normally needed for safe telehandler work?
Question 11 of 25
A buried void is suspected where a stabiliser would bear. What should happen?
Question 12 of 25
A load chart specifies stabilisers deployed for the intended lift. What must the operator do?
Question 13 of 25
How should normal travel with a load be planned?
Question 14 of 25
Why is turning too fast particularly hazardous?
Question 15 of 25
How should a slope be approached when the allowed configuration or direction is uncertain?
Question 16 of 25
What is the preferred way to protect pedestrians from a working telehandler?
Question 17 of 25
Which visibility issue should a telehandler assessment consider?
Question 18 of 25
An appointed signaller disappears from view during reversing. What should the driver do?
Question 19 of 25
Who should operate the telehandler?
Question 20 of 25
What should a daily pre-use check follow?
Question 21 of 25
A pre-use check finds a safety-critical brake fault. What is the correct action?
Question 22 of 25
A cracked fork is found before loading. What should happen?
Question 23 of 25
Can a worker be raised standing directly on telehandler forks?
Question 24 of 25
A bulky load blocks the driver's view of the travel route. What should be arranged?
Question 25 of 25
Does passing this quiz authorise a person to use every telehandler attachment?
About This Quiz
Test telehandler hazard awareness with 25 practical questions on attachments, capacity charts, load centres, reach, stability, ground support, visibility, pedestrian separation and pre-use inspections. Each answer includes an explanation for further study.
How to use the quiz
Choose one answer for each question. The pass mark is 70%, with no time limit. Answer choices are shuffled, explanations are shown and retakes are allowed. Review missed answers before trying again.
Scope and standards
This is independent practice material, not an official HSE or manufacturer examination, training-scheme assessment or operator authorisation. It draws on Great Britain HSE guidance and JLG manufacturer explanations. Manufacturer examples are not universal specifications: use the actual machine and attachment manuals and approved charts. No general slope, load-centre or capacity number in this quiz authorises an actual operation.
Primary sources
Sources reviewed on 18 November 2026. Consult the current applicable requirements and equipment instructions before real work.
Safe forklift operation depends on the truck, its load, the travel route, and the people nearby. This quiz brings these factors together through everyday operating decisions.
Test workshop lifting knowledge with 25 questions on overhead cranes, hoists, inspections, load control and safe operation. Includes answers and explanations.
Practise crane hand signals with 25 questions on OSHA standard gestures, safe communication and signal-person duties. Includes answers and explanations.
Test sling inspection knowledge with 25 questions on wire rope, chain and webbing damage, markings and safe use. Includes correct answers and explanations.